21.4.7.8 ST_BendPoint

This simple type defines where a bend is to occur within a connection between two nodes.

This simple type’s contents are a restriction of the W3C XML Schema token datatype.

This simple type is restricted to the values

listed in the following table:

Enumeration Value

Description

The bend is to occur at the beginning of the connection.

The default bend is used. By default connections bend in the center.

The bend is to occur at the end of the connection.

[Note: The W3C XML Schema definition of this simple type’s content model (ST_BendPoint) is located in A.5.3. end note]