20.1.8.30 fillRect

This element specifies a fill rectangle. When stretching of an image is specified, a source rectangle, srcRect, is scaled to fit the specified fill rectangle.

Each edge of the fill rectangle is defined by a percentage offset from the corresponding edge of the shape’s bounding box. A positive percentage specifies an inset, while a negative percentage specifies an outset. [Note: For example, a left offset of 25% specifies that the left edge of the fill rectangle is located to the right of the bounding box’s left edge by an amount equal to 25% of the bounding box’s width. end note]

[Example:

<a:blipFill>
  <a:blip r:embed="rId2"/>
  <a:stretch>
    <a:fillRect b="10000"
  </a:stretch>
</a:blipFill>

The above image is stretched to fill the entire rectangle except for the bottom 10% and rightmost 25%.

end example]

Attributes

t (Top Offset)

Specifies the top edge of the rectangle.

The possible values for this attribute are defined by the ST_Percentage simple type (20.1.10.40).

r (Right Offset)

Specifies the right edge of the rectangle.

The possible values for this attribute are defined by the ST_Percentage simple type (20.1.10.40).

l (Left Offset)

Specifies the left edge of the rectangle.

The possible values for this attribute are defined by the ST_Percentage simple type (20.1.10.40).

b (Bottom Offset)

Specifies the bottom edge of the rectangle.

The possible values for this attribute are defined by the ST_Percentage simple type (20.1.10.40).

[Note: The W3C XML Schema definition of this element’s content model (CT_RelativeRect) is located in A.4.1. end note]